Configuring Ripng Route Redistribution; Tuning And Optimizing The Ripng Network; Configuring Ripng Timers - H3C S5800 Series Configuration Manual

To do...
Configure a RIPng preference

Configuring RIPng Route Redistribution

Follow these steps to configure RIPng route redistribution:
To do...
Enter system view
Enter RIPng view
Configure a default routing metric
for redistributed routes
Redistribute routes from another
routing protocol

Tuning and Optimizing the RIPng Network

This section describes how to tune and optimize the performance of the RIPng network as well as
applications under special network environments. Before tuning and optimizing the RIPng network,
complete the following tasks:
Configure a network layer address for each interface
Configure the basic RIPng functions
This section covers the following topics:

Configuring RIPng Timers

Configuring Split Horizon and Poison Reverse
Configuring Zero Field Check on RIPng Packets
Configuring the Maximum Number of Equal Cost Routes for Load Balancing
Configuring RIPng Timers
You can adjust RIPng timers to optimize the performance of the RIPng network.
Follow these steps to configure RIPng timers:
Use the command...
preference [ route-policy
route-policy-name ] preference
Use the command...
system-view
ripng [ process-id ]
default cost cost
import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | route-policy
route-policy-name ] *
8-7
Remarks
Optional
By default, the RIPng preference is
100.
Remarks
––
––
Optional
The default metric of redistributed
routes is 0.
Required
No route redistribution is
configured by default.