One-Shot Mode - Renesas M16C FAMILY Hardware Manual

Under development
Preliminary specification
Specifications in this manual are tentative and subject to change.
R8C/11 Group

14.1 One-shot Mode

In one-shot mode, the input voltage on one selected pin is A-D converted once. Table 14.2 lists the
specifications of one-shot mode. Figure 14.4 shows the ADCON0 and ADCON1 registers in one-
shot mode.
Table 14.2 One-shot Mode Specifications
Item
Function
Start condition
Stop condition
Interrupt request generation timing End of A-D conversion
Input pin
Reading of result of A-D converter Read A-D register
Rev.0.91 2003 Sep 08
Input voltage on one pin selected by CH2 to CH0 and ADGSEL0 bit is A-D
converted once.
Set ADST bit to "1"
• Completion of A-D conversion (ADST bit is set to "0")
• Set ADST bit to "0"
One of AN to AN
0
page 127 of 184
Specification
, as selected
11
14. One-shot mode