Renesas M16C FAMILY Hardware Manual page 187

Under development
Preliminary specification
Specifications in this manual are tentative and subject to change.
R8C/11 Group
(7) Stop Mode
When shifting to stop mode, the following settings are required:
• Set the FMR01 bit to "0" (CPU rewrite mode disabled) and disable DMA transfers before setting
the CM10 bit to "1" (stop mode).
• Execute the JMP.B instruction subsequent to the instruction which sets the CM10 bit to "1" (stop
mode)
Example program
(8) Ring Oscillator Low Power Dissipation Mode
If the CM05 bit is set to "1" , the following commands must not be executed.
• Program
• Block erase
Rev.0.91 2003 Sep 08
BSET
JMP.B
L1:
Program after returning from stop mode
page 177 of 184
0, CM1 ; Stop mode
L1
19. Usage Notes