GE MiCOM P40 Technical Manual page 794

Appendix B -Settings and Signals
MENU TEXT
IEC61850 versions only. Indicates the MAC address of the rear Ethernet port.
NIC Tunl Timeout
IEC61850 versions only. Duration of time waited before an inactive tunnel to MiCOM S1 Studio is reset.
NIC Link Report
IEC61850 versions only.
Configures how a failed/unfitted network link (copper or fiber) is reported:
Alarm - an alarm is raised for a failed link
Event - an event is logged for a failed link
None - nothing reported for a failed link
REAR PORT2 (RP2)
RP2 versions only.
RP2 Protocol
RP2 versions only. Indicates the communications protocol that will be used on the rear communications port.
RP2 Card Status
RP2 versions only. Displays the status of the card in RP2
RP2 Port Config
RP2 versions only. This cell defines whether an electrical EIA(RS)232, EIA(RS)485 or KBus is being used for communication.
RP2 Comms Mode
RP2 versions only. The choice is either IEC 60870 FT1.2 for normal operation with 11-bit modems, or 10-bit no parity.
RP2 Address
RP2 versions only. This cell sets the unique address for the relay such that only one relay is accessed by master station software.
RP2 InactivTimer
RP2 versions only. This cell controls how long the relay will wait without receiving any messages on the rear port before it reverts to its
default state, including resetting any password access that was enabled.
RP2 Baud Rate
RP2 versions only. This cell controls the communication speed between relay and master station. It is important that both relay and master
station are set at the same speed setting.
NIC Protocol
DNP 3.0 over Ethernet versions only. Indicates that DNP 3.0 will be used on the rear Ethernet port.
IP Address
DNP 3.0 over Ethernet versions only. Indicates the IP address of the relay
Subnet Mask
B48
COL ROW DEFAULT SETTING
0E 64 5
0E 6A Alarm
0E 80
0E 81 Courier
0E 84
0E 88 EIA232 (RS232)
0E 8A IEC60870 FT1.2
0E 90 255
0E 92 15
0E 94 19200 bits/s
0E A0 DNP 3.0
0E A1 0.0.0.0
0E A2 0.0.0.0
DESCRIPTION
From 1 to 30 in steps of 1
[Courier Number (time-minutes)]
Alarm
Event
None
[Indexed String]
Courier
IEC870-5-103
Modbus
DNP 3.0
[Indexed String]
Unsupported
Card Not Fitted
EIA232 OK
EIA485 OK
K Bus OK
[Indexed String]
EIA232 (RS232)
EIA485 (RS485)
K-Bus
[Indexed String]
IEC60870 FT1.2 Frame
10-bit no parity
[Indexed String]
From 0 to 255 in steps of 1
[Unsigned Integer (16 bits)]
From 1 to 30 in steps of 1
[Courier Number (time-minutes)]
9600 bits/s
19200 bits/s
38400 bits/s
[Indexed String]
UCA 2.0
UCA 2.0 GOOSE
IEC61850
DNP3.0
[Indexed String]
IP Address
[ASCII Text]
Subnet Mask
[ASCII Text]
AVAILABLE OPTIONS
P446SV-TM-EN-1
P446SV