Rear Panel; Figure 7: Rear View Of Populated Case - GE MiCOM P40 Technical Manual

Hide thumbs Also See for MiCOM P40:

Table of Contents

Chapter 3 - Hardware Design

REAR PANEL

The MiCOM P40Agile Modular series uses a modular construction. Most of the internal workings are on boards and

modules which fit into slots. Some of the boards plug into terminal blocks, which are bolted onto the rear of the

unit. However, some boards such as the communications boards have their own connectors. The rear panel

consists of these terminal blocks plus the rears of the communications boards.

The back panel cut-outs and slot allocations vary. This depends on the product, the type of boards and the

terminal blocks needed to populate the case. The following diagram shows the rear view of a 40TE. The IEC

61850-9-2LE interface is highlighted in grey.

This diagram is a typical example and may not show the exact same arrangement of boards as your particular model. Refer

to the Cortec for product details.

P446SV-TM-EN-1