Table of Contents
Advertisement
The module is wired through the terminal blocks located at the rear of the unit. The maximum recommended cable
section for this terminal board, with the appropriate terminal, is 6 mm2 (AWG 10).
HID inputs are composed of three elements:
•
Stabilizing resistor
•
MOV
•
Contact from latching relay
Inputs vary depending on the HID model chosen. Thus, if the model corresponds to a type 1 application in the model
selection list, HID will have one single input; two for a type 2 application and three for a type 3 application.
HIDs can be supplied with or without latching relay.
If the unit includes a latching relay, then MOVs and resistors are dimensioned according to the HLB tripping time,
whereas if the unit does not include a latching relay, resistor and varistors are able to support a tripping time of
250ms.
3-4
HARDWARE
1
5
9
1
2
6
10
2
3
7
11
3
4
8
12
4
A
C
1
5
9
1
2
6
10
2
3
7
11
3
4
8
12
4
FIGURE 3-3 REAR TERMINALS DIAGRAM
HID High Impedance Differential Module
3.1.6.
5
9
6
10
7
11
8
12
B
D
5
9
6
10
7
11
8
12
REAR DESCRIPTION
3.1.7.
INPUTS
GEK-113064
- Quick Links:
- Mounting & Wiring
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Multilin HID and is the answer not in the manual?
Questions and answers
Wiring diagram for HID30 (w/o latching relays) is missing. Only for HID32 is available. Please provide it. Thank you!
The wiring diagram for the GE Multilin HID30 without latching relays can be found in the external wiring diagram section of the manual. It is advised to check the corresponding external wiring diagram specific to the HID model being used.
This answer is automatically generated