Table of Contents
Advertisement
Accessories
Equipment Required
but Not Supplied
Recommended Test
Equipment
Reflection or
Transmission
Measurements
A Detection
Specifications and
Supplemental
Characteristics
1-2 General Information
able 6-2 lists accessories available for use with these detectors.
able 1-4 lists the equipment required to test the detectors. You
may substitute any equipment that meets the indicated critical
speci cations.
Re
ection and transmission measurements require the following
equipment:
One or more detectors.
An Agilent 8757D scalar network analyzer.
of the following:
One
A directional bridge.
A directional coupler.
A sweep oscillator or synthesized sweeper.
For ratio measurements use:
A power splitter or dual directional coupler.
AC detection requires the equipment listed above,
source capable of 27.778 kHz squarewave amplitude modulation, or
an external modulator.
able 1-1 and able 1-2 list detector speci cations which are the
performance standards or limits against which you can test the
device.
able 1-3 lists supplemental (typical, non-warranted) detector
characteristics.
either a signal
plus
Advertisement
Table of Contents
