Performance Tests; Equipment Required - Agilent Technologies 85025A User's And Service Manual

Performance Tests

Use the procedures in this chapter to test the detector's electrical performance
to the speci cations listed in \General Information." None of these tests require
access to the detector's interior.
o completely test each detector, three tests are required:
1. return loss
2. frequency response
3. absolute power/dynamic accuracy
Note
For information on automating the Frequency Response
Performance est, see the chapter titled \Program Listing."

Equipment Required

Preceding each test is a list that describes the equipment required to perform
that particular test. You may substitute any equipment that meets the indicated
critical speci cations. See able 4-1 for an overall list of required equipment.
Note
Before you proceed with the performance tests, gage the
input connector on the detector and enter the results in the
Performance Test Record
For instructions on gaging the detector's input connector, see
\Detector Maintenance."
Ag lent 85025A/B/D/E
at the end of \Performance ests."
Performance T ests
4
4-1