Calibration Procedure; Introduction; Environmental Conditions - Keithley 6517B Reference Manual

In this section:

Introduction ............................................................................ 15-1

Calibration Procedure ............................................................ 15-1

Calibration command reference ........................................... 15-17
Introduction
This section discusses the calibration procedure for the Keithley Instruments Model 6517B.
The information in this section is intended for qualified service personnel only. Do not
attempt these procedures unless you are qualified to do so. Some of these procedures may
expose you to hazardous voltages, which could cause personal injury or death if contacted.
Use appropriate safety precautions when working with hazardous voltages.
If the instrument is still under warranty and its performance is outside specified limits, contact your
Keithley Instruments representative or the factory to determine the correct course of action.
Calibration Procedure
This section describes the four-part procedure for calibrating the Model 6517B:

Meter calibration (voltage, current, and charge ranges)

Temperature calibration

Humidity calibration

Voltage source calibration
Because the calibration procedure must be performed remotely using SCPI commands, a computer
with suitable software for controlling the instrument over RS-232 or GPIB is required.

Environmental conditions

Calibration should be performed at an ambient temperature of 23 °C +/- 5 °C and a relative humidity
of 70 % or less.
Calibration procedure
Section 15