Ieee-488 Trigger Model - Keithley 6517B Reference Manual

Section 11: Remote operations

IEEE-488 trigger model

The following information describes the operation process of the Model 6517B over the IEEE-488
bus. The flowchart below, which summarizes operation over the bus, is called the Trigger model. It is
called the trigger model because operation is controlled by SCPI commands from the Trigger
subsystem (see
included in the trigger model.
See Triggering
11-16
SCPI command reference
(on page 7-1) for additional trigger information.
Figure 102: IEEE-488 trigger model
Model 6517B Electrometer Reference Manual
(on page 14-1)). Notice that key SCPI commands are
6517B-901-01 Rev. C / August 2015