Table of Contents
Advertisement
Model 6517B Electrometer Reference Manual
*SAV (save the current setup in memory)
This command saves the Model 6517B present setup configuration in memory for later recall.
Usage
*SAV <NRf>
<NRf>
Details
The *SAV command is used to save the current instrument setup configuration in memory for later
recall. Any control affected by *RST can be saved by the *SAV command. The *RCL command is
used to restore the instrument to a saved setup configuration.
Also see
*RCL (recall)
*SRE <NRf> (service request enable), *SRE? (service request
enable query)
These commands program and read the service request enable register.
Usage
*SRE <NRf>
*SRE?
<NRf>
Details
The *SRE command is used to program the service request enable register. This command is sent
with the decimal equivalent of the binary value that determines the desired state (0 or 1) of each bit in
the register. This register is cleared on power-up.
This enable register is used along with the status byte register to generate service requests (SRQ).
With a bit in the service request enable register set, an SRQ occurs when the corresponding bit in the
status byte register is set by an appropriate event. For details on register structure, refer to
structure
6517B-901-01 Rev. C / August 2015
Specify memory location: 0 to 9
(on page 12-10)
0: Clears enable register
1: Set MSB bit (Bit 0)
4: Set EAV bit (Bit 2)
8: Set QSB bit (Bit 3)
16: Set MAV bit (Bit 4)
32: Set ESB bit (Bit 5)
128: Set OSB bit (Bit 7)
255: Sets all bits
(on page 13-1).
Section 12: Common commands
Status
12-11
Advertisement
Table of Contents
