Table of Contents
Advertisement
Model 6517B Electrometer Reference Manual
:MDELay <NRf>
This configuration command is used to specify the measure time for the specified test.
Usage
:TSEQuence:DLEakage:MDELay <NRf>
:TSEQuence:RVCoefficient:MDELay[1] <NRf>
:TSEQuence:RVCoefficient:MDELay2 <NRf>
:MDELay?
<NRf>
Details
This command is used to specify the measure time for the specified test. Note that the resistor
voltage coefficient test uses two measure delays; delay 1 and delay 2.
This configuration command is used for the following tests:
Diode leakage test
Resistor voltage coefficient test
:TSEQuence:DLEakage:MDELay <NRf> specifies the measure delay for a diode leakage test.
:TSEQuence:RVCoefficient:MDELay[1] <NRf> specifies measure delay 1 for the resistor
voltage coefficient test.
:TSEQuence:RVCoefficient:MDELay2 <NRf> specifies measure delay 2 for the resistor voltage
coefficient test.
:MDELay? queries the measure delay.
Also see
None
6517B-901-01 Rev. C / August 2015
0 to 99999.9 Measure delay in seconds (resistor voltage coefficient test)
0 to 10000 Delay in seconds (diode leakage test)
Section 14: SCPI command reference
14-161
Advertisement
Table of Contents
