Table of Contents
Advertisement
Section 14: SCPI command reference
Command
:RSWitch?
:USER
:RSELect
<name>
:RSELect?
:KSURface
<NRf>
:KSURface?
:KVOLume <NRf>
:KVOLume?
:CHARge
:APERture
:AUTO
:AUTO
:AUTO?
:APERture?
:NPLCycles
:AUTO
:AUTO
:AUTO?
:NPLCycles?
:CHARge
:RANGe
[:UPPer]
[:UPPer]?
:AUTO
:AUTO
:LGRoup <name> Specify HIGH or LOW auto range limit
:LGRoup?
:AUTO?
:REFerence
:STATe
:STATe?
:ACQuire
:REFerence?
:DIGits
:AUTO <b>
:AUTO ONCE
:AUTO?
:DIGits?
:AVERage
14-18
Description
Query switch setting (surface or volume)
Path to configure user test fixture:
Specify measurement type (SURFace or
VOLume)
Query measurement type
Surface; specify Ks (0.001 to 999.999)
Query, Ks
Volume; specify Kv (0.001 to 999.999)
Query Kv
Path to configure Coulombs
<n>
Set integration rate in seconds (166.67e-6
to 200e-3)
<b>
Enable or disable auto aperture
ONCE
Enable and then disable auto aperture
Query auto aperture
Query aperture (integration rate)
<n>
Set integration rate (line cycles; 0.01 to
10)
<b>
Enable or disable auto NPLC
ONCE
Enable and then disable auto NPLC
Query auto line cycle integration
Query line cycle integration rate
Path to configure measurement range:
<n>
Select range (0 to +2.1e-6)
Query range
<b>
Enable or disable auto range
ONCE
Set range based on present input signal
Query auto range limit
Query auto range
<n>
Specify reference (-2.1e-6 to +2.1e-6)
<b>
Enable or disable reference
Query state of reference
Use input signal as reference
Query reference value
<n>
Specify measurement resolution (4 to 7)
Enable or disable auto resolution
Enable and then disable auto resolution
Query auto resolution
Query resolution
Path to control the average filter
Model 6517B Electrometer Reference Manual
Default parameter
SURFace
1.000
1.000
(Note 1)
OFF
1
OFF
2e-6
ON
HIGH
0
OFF
6
6517B-901-01 Rev. C / August 2015
SCPI
Advertisement
Table of Contents
