Terminal Monitor - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

Predefined user roles
network-admin
Parameters
severity: Specifies the lowest level of the logs that can be output to the current terminal, in the range
of 0 to 7.
Usage guidelines
If you specify the lowest level of the logs that can be output to the current terminal, the device outputs
the logs with a severity level higher than or equal to the specified level. For example, if you set the
lowest level of the logs that can be output to the current terminal to 6 (informational), logs with a
severity value from 0 to 6 will be output.
The configuration of this command is valid for only the current connection between the terminal and
the device. If a new connection is established, the display of logs on the terminal restores the default.
Examples
# Set the lowest level of the logs that can be output on the monitor terminal to 7 (Debug).
<Sysname> terminal logging level 7

terminal monitor

Use terminal monitor to enable the display of logs on the current terminal.
Use undo terminal monitor to disable the display of logs on the current terminal.
Syntax
terminal monitor
undo terminal monitor
Default
Monitoring of logs is enabled on the console and disabled on the monitor terminal.
Views
User view
Predefined user roles
network-admin
Usage guidelines
The configuration of this command is valid for only the current connection between the terminal and
the device. If a new connection is established, the default is restored.
Examples
# Enable the display of logs on the current terminal.
<Sysname> terminal monitor
The current terminal is enabled to display logs.
107