Display Ptp Parent - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

Field
Transport of PTP
Force state
Announce interval (log mean)
Announce receipt time out
Sync interval (log mean)
Delay request interval (log
mean)
Peer delay request interval
(log mean)
Mean path delay

display ptp parent

Use display ptp parent to display parent node information for the PTP device.
Syntax
display ptp parent
Views
Any view
Predefined user roles
network-admin
network-operator
Usage guidelines
Parent node information is not displayed, if you:
•
Specify neither a PTP profile nor a PTP mode.
•
Specify the clock node type as e2etc or p2ptc.
•
Configure the ptp active force-state command.
Examples
# Display parent node information for the PTP device.
<Sysname> display ptp parent
Parent clock:
Parent clock ID
Parent port number
Observed parent offset (log variance)
Observed parent clock phase change rate : N/A
Grandmaster clock:
Description
PTP messages are transported by:
•
User Datagram Protocol (IPv4).
•
IEEE 802.3/Ethernet.
Whether the force state is configured:
•
Yes.
•
No.
Announce message sending interval (in seconds) = 2
the value for the value exponent).
Timeout value for receiving announce messages. If a member node does
not receive any announce message from the master node within the
specified value, it considers the master node invalid.
Sync message sending interval (in seconds) = 2
value for the value exponent).
Minimum delay request message sending interval (in seconds) = 2
field displays the value for the value exponent).
Peer delay request message sending interval (in seconds) = 2
displays the value for the value exponent).
Mean path delay, in nanoseconds.
: 000FE2-FFFE-FF0005
: 15
: N/A
55
value
(this field displays
value
(this field displays the
value
(this
value
(this field