Reaction Checked-Element Probe-Fail (For Trap) - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

[Sysname-nqa-admin-test-icmp-echo] reaction 1 checked-element probe-duration
threshold-type average threshold-value 50 5 action-type trap-only
# Create reaction entry 2 for monitoring the probe duration of ICMP echo operation, and set the
upper limit to 50 milliseconds and the lower limit to 5 milliseconds. Before the NQA operation starts,
the initial state of the reaction entry is invalid. After the operation, the accumulated probe duration is
checked against the threshold range. If the total number of threshold violations reaches or exceeds
10, the state of the entry is set to over-threshold. If it is below the lower threshold, the state of the
entry is set to below-threshold. Once the state of the reaction entry changes, a trap message is
generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] reaction 2 checked-element probe-duration
threshold-type accumulate 10 threshold-value 50 5 action-type trap-only
# Create reaction entry 3 for monitoring the probe duration time of ICMP echo operation, and set the
upper limit to 50 milliseconds and the lower limit to 5 milliseconds. Before the NQA operation starts,
the initial state of the reaction entry is invalid. After the operation, the consecutive probe duration is
checked against the threshold range. If the total number of consecutive threshold violations reaches
or exceeds 10, the state of the entry is set to over-threshold. If it is below the lower threshold, the
state of the entry is set to below-threshold. Once the state of the reaction entry changes, a trap
message is generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] reaction 3 checked-element probe-duration
threshold-type consecutive 10 threshold-value 50 5 action-type trap-only

reaction checked-element probe-fail (for trap)

Use reaction checked-element probe-fail to configure a reaction entry for monitoring the probe
failures of the operation.
Use undo reaction to delete the specified reaction entry.
Syntax
reaction
accumulate-occurrences | consecutive consecutive-occurrences } [ action-type { none |
trap-only } ]
undo reaction item-number
Default
No reaction entry for monitoring probe failures is configured.
Views
DHCP/DLSw/DNS/FTP/HTTP/SNMP/TCP operation view
ICMP/UDP echo operation view
Predefined user roles
network-admin
Parameters
item-number: Assigns an ID to the reaction entry, in the range of 1 to 10.
threshold-type: Specifies a threshold type.
item-number checked-element probe-fail threshold-type
223
{ accumulate