Rtm Cli-Policy - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

NOTE:
EAA does not count log messages generated by the RTM module when it counts log matches.
You can configure only one event for a monitor policy. If the monitor policy already contains an event,
the new event replaces the old event.
Examples
# Configure a CLI-defined policy to monitor Syslog messages for level 3 to level 0 messages that
contain the down string. Enable the system to execute the policy when five log matches are found
within 6 seconds.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] event syslog priority 3 msg down occurs 5 period 6

rtm cli-policy

Use rtm cli-policy to create a CLI-defined EAA monitor policy and enter its view.
Use undo rtm cli-policy to delete a CLI-defined monitor policy.
Syntax
rtm cli-policy policy-name
undo rtm cli-policy policy-name
Default
No CLI-defined monitor policy exists.
Views
System view
Predefined user roles
network-admin
Parameters
policy-name: Specifies the name of a CLI-defined monitor policy, a case-sensitive string of 1 to 63
characters.
Usage guidelines
You must create a CLI-defined monitor policy before you can use the CLI to configure settings in the
policy.
You can assign the same policy name to a CLI-defined policy and a Tcl-defined policy. However, you
cannot assign the same name to policies that are the same type.
For a CLI-defined monitor policy to take effect, you must execute the commit command after you
complete configuring the policy.
Examples
# Create a CLI-defined policy and enter its view.
<Sysname> system-view
[Sysname] rtm cli-policy test
Related commands
commit
320