Information Center Configuration Task List; Outputting Logs To The Console; Outputting Logs To The Monitor Terminal - HPE FlexFabric 5700 Series Network Management And Monitoring Configuration Manual

Information center configuration task list

Task at a glance
Perform at least one of the following tasks:
•

Outputting logs to the console

•

Outputting logs to the monitor terminal

•
Outputting logs to a log host
•
Outputting logs to the log buffer
•
Saving logs to the log file
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
Outputting logs to the console
Step
1. Enter system view.
2. Enable the information
center.
3. Configure an output rule for
the console.
4. (Optional.) Configure the
timestamp format.
5. Return to user view.
6. (Optional.) Enable log output
to the console.
7. Enable the display of debug
information on the current
terminal.
8. (Optional.) Set the lowest
severity level of logs that can
be output to the console.
Outputting logs to the monitor terminal
Monitor terminals refer to terminals that log in to the device through the VTY line.
Managing security logs
Saving diagnostic logs to the diagnostic log file
Configuring the maximum size of the trace log file
Enabling synchronous information output
Enabling duplicate log suppression
Disabling an interface from generating link up or link down logs
Setting the minimum storage time for logs
Command
system-view
info-center enable
info-center source
{ module-name | default }
{ console | monitor | logbuffer |
logfile | loghost } { deny | level
severity }
info-center timestamp { boot |
date | none }
quit
terminal monitor
terminal debugging
terminal logging level severity
71
Remarks
N/A
By default, the information center
is enabled.
For information about default
output rules, see "Default output
rules for logs."
By default, the timestamp format
is date.
N/A
The default setting is enabled.
By default, the display of debug
information is disabled on the
current terminal.
The default setting is 6
(informational).