Table 11: Serial Terminal Program Configuration; Table 12: Configuration Wizard Session - HPE StoreFabric M-Series Hardware User Manual

Configure a serial terminal program (for example, HyperTerminal, minicom, or Tera Term)
Step 2.
on your host PC with the settings described in
get the CLI prompt of the system.
Table 11 - Serial Terminal Program Configuration
Parameter
Baud Rate
Data bits
Stop bits
Parity
Flow Control
Login as admin and use admin as password. On the first login, the MLNX-OS con-
Step 3.
figuration wizard will start.
To configure network attributes and other initial parameters to the system, follow the con-
Step 4.
figuration wizard as shown in
Table 12 - Configuration Wizard Session
Wizard Session Display
Mellanox configuration wizard
Do you want to use the wizard
for initial configuration? yes
Step 1: Hostname? [switch-1]
Step 2: Use DHCP on mgmt0
interface? [no] yes
Step 3: Enable IPv6? [yes]
Step 4: Enable IPv6 auto-con-
fig (SLAAC) on mgmt0 inter-
face? [no]
Step 5: Enable DHCPv6 on
mgmt0 interface? [no]
User Manual
Table
Setting
115200
8
1
None
None
Table 12.
You must perform this configuration the first time you operate
the system or after resetting the system. Type 'y' and then press
<Enter>.
If you wish to accept the default hostname, press <Enter>. Other-
wise, type a different hostname and press <Enter>.
Perform this step to obtain an IP address for the system. (mgmt0
is the management port of the system).
If you wish the DHCP server to assign the IP address, type 'yes'
and press <Enter>.
If you type 'no' (no DHCP), then you will be asked whether you
wish to use the 'zeroconf' configuration or not.
If you enter 'no' (no Zeroconf), you must enter a static IP, and the
session will continue.
The management interface will be able to use IPv6 addresses.
If you enter "no" (no IPv6), you will automatically be referred to
Step 6.
This turns on auto-configuration of the IPv6 addresses. This is
unsuitable for DHCPv6.
To enable DHCPv6 on the MGMT0 interface.
11. Once you perform that, you should
Comments
Installation
49