Cwmp Cpe Provision-Code; Cwmp Cpe Stun Enable - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

Related commands
cwmp cpe username

cwmp cpe provision-code

Use cwmp cpe provision-code to configure the provision code of the CPE.
Use undo cwmp cpe provision-code to restore the default.
Syntax
cwmp cpe provision-code provision-code
undo cwmp cpe provision-code
Default
The provision code is PROVISIONCODE.
Views
CWMP view
Predefined user roles
network-admin
Parameters
provision-code: Specifies a provision code, a string of 1 to 64 characters. The string can contain
uppercase letters, digits, and the full stop (.).
Usage guidelines
The provision code identifies a set of services and parameters subscribed to by the CPE. When the
CPE initiates a session to the ACS, the CPE must send the provision code in the Inform message.
The CPE can have only one provision code. If you use the command multiple times, the final
provision code takes effect.
Examples
# Set the provision code to H20130525.
<Sysname> system
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe provision-code H20130525

cwmp cpe stun enable

Use cwmp cpe stun enable to enable NAT traversal for the connection requests from the ACS to
reach the CPE through a NAT gateway.
Use undo cwmp cpe stun enable to restore the default.
Syntax
cwmp cpe stun enable
undo cwmp cpe stun enable
Default
NAT traversal is disabled for CWMP.
Views
CWMP view
335