Ptp Min-Delayreq-Interval - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

<Sysname> system-view
[Sysname] ptp profile 1588v2
[Sysname] ptp mode oc
[Sysname] interface fortygige 1/0/1
[Sysname-FortyGigE1/0/1] ptp force-state slave
Related commands
•
ptp mode
•
ptp profile
•
ptp slave-only

ptp min-delayreq-interval

Use ptp min-delayreq-interval to configure the minimum interval for sending delay request
messages.
Use undo ptp min-delayreq-interval to restore the default.
Syntax
ptp min-delayreq-interval value
undo ptp min-delayreq-interval
Default
If the PTP profile is IEEE 1588 version 2, the minimum interval for sending delay request messages
0
is 1 (2 ) second.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
value: Specifies the minimum interval for sending delay request messages (in seconds). The
intervals use log base 2 values. The value range for the value argument is –4 to 6.
Usage guidelines
This command is available only after you specify a PTP profile and a PTP mode.
If the PTP profile is IEEE 802.1AS, you cannot execute this command.
Examples
# Configure the minimum interval for sending delay request messages as 4 (2
FortyGigE 1/0/1.
<Sysname> system-view
[Sysname] ptp profile 1588v2
[Sysname] ptp mode oc
[Sysname] interface fortygige 1/0/1
[Sysname-FortyGigE1/0/1] ptp min-delayreq-interval 2
Related commands
•
ptp mode
•
ptp profile
69
2
) seconds on