Port Mirroring Commands; Display Mirroring-Group - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

Hide thumbs Also See for FlexFabric 5930 Series:
Table of Contents

Advertisement

Port mirroring commands

The port mirroring commands are available on Layer 2 Ethernet interfaces, Layer 3 Ethernet
interfaces, and FC interfaces. The term "interface" in this chapter collectively refers to these types of
interfaces. You can use the port link-mode command to configure an Ethernet port as a Layer 2 or
Layer 3 interface (see Layer 2—LAN Switching Configuration Guide).

display mirroring-group

Use display mirroring-group to display mirroring group information.
Syntax
display mirroring-group { group-id | all | local | remote-destination | remote-source }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
group-id: Specifies a mirroring group by its number in the range of 1 to 4.
all: Specifies all mirroring groups.
local: Specifies local mirroring groups.
remote-destination: Specifies remote destination groups.
remote-source: Specifies remote source groups.
Usage guidelines
Mirroring group information includes the type, status, and content of a mirroring group. It is sorted by
mirroring group number.
Examples
# Display information about all mirroring groups.
<Sysname> display mirroring-group all
Mirroring group 1:
Type: Local
Status: Active
Mirroring port:
FortyGigE1/0/1
Monitor port: FortyGigE1/0/2
Mirroring group 3:
Type: Local
Status: Active
Mirroring port:
FortyGigE1/0/1
FortyGigE1/0/2
Monitor port: FortyGigE1/0/3
Inbound
Inbound
Both
246

Advertisement

Table of Contents
loading

Table of Contents