Ptp Mode; Ptp Pdelay-Req-Interval - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

ptp mode

Use ptp mode to specify a clock node type for the device.
Use undo ptp mode to restore the default.
Syntax
ptp mode { bc | e2etc | e2etc-oc | oc | p2ptc | p2ptc-oc }
undo ptp mode
Default
No clock node type is specified.
Views
System view
Predefined user roles
network-admin
Parameters
bc: Specifies the clock node type as boundary clock (BC).
e2etc: Specifies the clock node type as end-to-end transparent clock (E2ETC).
e2etc-oc: Specifies the clock node type as E2ETC+OC.
oc: Specifies the clock node type as ordinary clock (OC).
p2ptc: Specifies the clock node type as peer-to-peer transparent clock (P2PTC).
p2ptc-oc: Specifies the clock node type as P2PTC+OC.
Usage guidelines
This command is available only after you specify a PTP profile.
If the PTP profile is IEEE 802.1AS, you cannot specify the clock node type as E2ETC or E2ETC+OC.
If you change the clock node type for the device, all the configurations except for the PTP profile will
be removed.
Examples
# Specify the clock node type as OC for the device.
<Sysname> system-view
[Sysname] ptp profile 1588v2
[Sysname] ptp mode oc
Related commands
ptp profile

ptp pdelay-req-interval

Use ptp pdelay-req-interval to configure the interval for sending peer delay request messages.
Use undo ptp pdelay-req-interval to restore the default.
Syntax
ptp pdelay-req-interval value
undo ptp pdelay-req-interval
70