Display Cwmp Status - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

Source IP interface
STUN state
SSL policy name
Table 79 Command output
Field
CWMP state
ACS URL
ACS username
ACS default URL
ACS default username
Periodic inform
Inform interval
Inform time
Wait timeout
Connection retries
Source IP interface
STUN state
SSL policy name
Related commands

display cwmp status

display cwmp status
Use display cwmp status to display CWMP state information.
Syntax
display cwmp status
Description
Status of CWMP: Enabled or Disabled.
Preferred ACS URL.
This field displays Null if no preferred ACS URL has been specified.
Username for the CPE to authenticate to the ACS.
Default ACS URL.
The CPE attempts to connect to the default ACS URL if no ACS URL has
been assigned to it through the cwmp acs url command, ACS, or DHCP.
This field displays Null if no default ACS URL has been configured.
Username for the CPE to authenticate to the default ACS URL.
This field displays Null if no username has been configured for authentication
to the default ACS URL.
Status of the periodic Inform feature: Enabled or Disabled.
Periodic Inform interval. The default interval is 600 seconds.
Date and time at which an Inform message is scheduled to be sent. If you do
not schedule an Inform sending, this field displays None.
Close-wait timer. This timer is configurable with the cwmp cpe wait timeout
command.
Number of attempts the CPE can make to retry a failed CWMP connection.
This field displays Unlimited if the default setting is used. The CPE retries a
failed session until the session is established with the ACS.
IP address of the specified CWMP connection interface. This field displays
None if you have not specified a CWMP connection interface.
Status of NAT traversal for CWMP: Enabled or Disabled.
For the connection request initiated from the ACS to reach the CPE, you must
enable NAT traversal when a NAT gateway resides between the CPE and the
ACS.
SSL client policy specified for the CPE to authenticate the ACS for
establishing an HTTPS connection. You must specify an SSL client policy
when HTTPS is used.
This field displays Null if you have not specified an SSL client policy.
339
: None
: Disable
: Null