HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference page 236

Syntax
reaction trap { path-change | probe-failure consecutive-probe-failures | test-complete |
test-failure [ cumulate-probe-failures ] }
undo reaction trap { path-change | probe-failure | test-complete | test-failure }
Default
No traps are sent to the NMS.
Views
DHCP/DLSw/DNS/FTP/HTTP/SNMP/TCP/voice operation view
ICMP/UDP echo operation view
UDP jitter operation view
UDP tracert operation view
Predefined user roles
network-admin
Parameters
path-change: Sends a trap when the UDP tracert operation detects a different path to the
destination.
probe-failure consecutive-probe-failures: Sends a trap to the NMS if the number of consecutive
probe failures in an operation is greater than or equal to consecutive-probe-failures. The value range
for the consecutive-probe-failures argument is 1 to 15. The system counts the number of
consecutive probe failures for each operation, so multiple traps might be sent.
test-complete: Sends a trap to indicate that the operation is completed.
test-failure: Sends a trap when an operation fails. For operations other than UDP tracert operation,
the system counts the total number of probe failures in an operation. If the number reaches or
exceeds the value for the cumulate-probe-failures argument, a trap is sent for the operation failure.
cumulate-probe-failures: Specifies the total number of probe failures in an operation. The value
range for the cumulate-probe-failures argument is 1 to 15. This argument is not supported by the
UDP tracert operation.
Usage guidelines
The UDP jitter and voice operations support only the test-complete keyword.
The UDP tracert operation supports the following keywords:
•
path-change.
•
test-complete.
•
test-failure without the cumulate-probe-failures argument.
Examples
# Configure the system to send a trap if five or more consecutive probe failures occur in an ICMP
echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] reaction trap probe-failure 5
227