Ptp Port-Mode - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

Default
The interval for sending peer delay request messages is 1 (2
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
value: Specifies the interval (in seconds) for sending peer delay request messages. The intervals
use log base 2 values. The value range for this argument is –4 to 6. If the PTP profile is IEEE 1588
version 2, the value range for this argument is 0 to 5.
Usage guidelines
This command is available only after you specify a PTP profile and a PTP mode.
Examples
# Configure the interval for sending peer delay request messages on FortyGigE 1/0/1 as 4 (2
seconds.
<Sysname> system-view
[Sysname] ptp profile 1588v2
[Sysname] ptp mode oc
[Sysname] interface fortygige 1/0/1
[Sysname-FortyGigE1/0/1] ptp pdelay-req-interval 2
Related commands
•
ptp mode
•
ptp profile

ptp port-mode

Use ptp port-mode to configure the port type as OC for a TC+OC (including E2ETC+OC and
P2PTC+OC) clock.
Use undo ptp port-mode to restore the default.
Syntax
ptp port-mode oc
undo ptp port-mode
Default
The type of all ports on an E2ETC+OC or a P2PTC+OC clock is TC.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
oc: Specifies the port type for a TC+OC clock as OC.
Usage guidelines
This command is available only after you specify a PTP profile and a PTP mode.
0
) second.
71
2
)