Action Syslog - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

Default
Monitor policies do not contain any actions.
Views
CLI-defined policy view
Predefined user roles
network-admin
Parameters
number: Specifies an action ID in the range of 0 to 231.
Usage guidelines
This command will not be executed if the device forms a single-chassis IRF fabric.
You can configure a series of actions to be executed in response to the event specified in a monitor
policy.
EAA executes the actions in ascending order of action IDs. You must make sure the execution order
is correct when you add actions to a policy.
Examples
# Configure an action for the CLI-defined policy test to perform an active/standby switchover.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 3 switchover

action syslog

Use action syslog to add a Syslog action to a monitor policy.
Use undo action to remove an action.
Syntax
action number syslog priority level facility local-number msg msg
undo action number
Default
Monitor policies do not contain any actions.
Views
CLI-defined policy view
Predefined user roles
network-admin
Parameters
number: Specifies an action ID in the range of 0 to 231.
priority level: Specifies the log severity level in the range of 0 to 7. A lower value represents a higher
severity level.
facility local-number: Specifies a logging facility by its facility number in the range of local0 to local7.
Facility numbers are used by a log host to identify log creation facilities for filtering log messages.
msg msg: Configures the log message body.
309