Ptp Announce-Interval - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

Views
System view
Predefined user roles
network-admin
Usage guidelines
This command is available only after you specify a PTP profile and a PTP mode.
Examples
# Activate the port role configuration.
<Sysname> system-view
[Sysname] ptp profile 1588v2
[Sysname] ptp mode oc
[Sysname] ptp active force-state
Related commands
•
ptp force-state
•
ptp mode
•
ptp profile

ptp announce-interval

Use ptp announce-interval to configure the interval for sending announce messages.
Use undo ptp announce-interval to restore the default.
Syntax
ptp announce-interval value
undo ptp announce-interval
Default
If the PTP profile is IEEE 1588 version 2, the announce message sending interval is 1 (2
If the PTP profile is IEEE 802.1AS, the announce message sending interval is 1 (2
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
value: Specifies the announce message sending interval (in seconds). The intervals use log base 2
values. If the PTP profile is IEEE 1588 version 2, the value range for the value argument is 0 to 4. If
the PTP profile is IEEE 802.1AS, the value range for the value argument is 0 to 6.
Usage guidelines
This command is available only after you specify a PTP profile and a PTP mode.
Examples
# Configure the announce message sending interval on FortyGigE 1/0/1 as 4 (2
<Sysname> system-view
[Sysname] ptp profile 1588v2
[Sysname] ptp mode oc
59
1
) second.
0
) second.
2
) seconds.