Cwmp Cpe Connect Interface; Cwmp Cpe Connect Retry - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

cwmp cpe connect interface

Use cwmp cpe connect interface to specify the CWMP connection interface.
Use undo cwmp cpe connect interface to restore the default.
Syntax
cwmp cpe connect interface interface-type interface-number
undo cwmp cpe connect interface
Default
No CWMP connection interface is specified.
Views
CWMP view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies the type and number of the CWMP connection interface.
Usage guidelines
CWMP connection interface is the interface that the CPE uses to communicate with the ACS. To
establish a CWMP connection, the CPE sends the IP address of this interface in the Inform message,
and the ACS replies to this IP address.
Typically, the CPE selects the CWMP connection interface automatically.
If the interface that connects the CPE to the ACS is the only Layer 3 interface that has an IP address
on the device, you do not need to specify the CWMP connection interface.
If the CPE has multiple Layer 3 interfaces, specify the interface that connects to the ACS as the
CWMP connection interface. This manual setting prevents incorrect CWMP connection interface
selection, which might occur with automatic selection.
Examples
Specify Vlan-interface1 as the CWMP connection interface.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe connect interface vlan-interface 1

cwmp cpe connect retry

Use cwmp cpe connect retry to configure the maximum number of attempts the CPE can make to
retry a failed CWMP connection.
Use undo cwmp cpe connect retry to restore the default.
Syntax
cwmp cpe connect retry times
undo cwmp cpe connect retry
Default
The CPE retries a failed connection until the connection is established with the ACS.
331