Ptp Syn-Interval - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

To enable the PTP functions to operate on the port, you must execute this command, if PTP
messages are transported by UDP and IPv4.
Examples
# Configure the source IP address as 3.5.1.5 for the PTP message.
<Sysname> system-view
[Sysname] ptp profile 1588v2
[Sysname] ptp mode oc
[Sysname] ptp source 3.5.1.5
Related commands
•
ptp mode
•
ptp profile
•
ptp transport-protocol

ptp syn-interval

Use ptp syn-interval to configure the interval for sending Sync messages.
Use undo ptp syn-interval to restore the default.
Syntax
ptp syn-interval value
undo ptp syn-interval
Default
If the PTP profile is IEEE 1588 version 2, the interval for sending Sync messages is 1 (2
If the PTP profile is IEEE 802.1AS, the interval for sending Sync messages is 1/8 (2
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
value: Specifies the Sync message sending interval (in seconds). The intervals use log base 2
values. If the PTP profile is IEEE 802.1AS, the value range for the value argument is -4 to 6. If the
PTP profile is IEEE 1588 version 2, the value range for the value argument is -1 to 1.
Usage guidelines
This command is available only after you specify a PTP profile and a PTP mode.
Examples
# Configure the Sync message sending interval on FortyGigE 1/0/1 as 2 (2
<Sysname> system-view
[Sysname] ptp profile 1588v2
[Sysname] ptp mode oc
[Sysname] interface fortygige 1/0/1
[Sysname-FortyGigE1/0/1] ptp syn-interval 1
Related commands
•
ptp mode
75
0
) second.
-3
) second.
1
) seconds.