Info-Center Loghost Source - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

loghost: Specifies a log host by its host name, a case insensitive string of 1 to 253 characters.
ipv4-address: Specifies an IPv4 log host by its IPv4 address.
ipv6 ipv6-address: Specifies an IPv6 log host by its IPv6 address
port port-number: Specifies the port number of the log host, in the range of 1 to 65535. The default is
514. It must be the same as the value configured on the log host. Otherwise, the log host cannot
receive system information.
facility local-number: Specifies a logging facility from local0 to local7 for the log host. The default
value is local7. Logging facilities are used to mark different logging sources, and query and filer logs.
Usage guidelines
The info-center loghost command takes effect only after the information center is enabled with the
info-center enable command.
The device supports a maximum of 20 log hosts.
Examples
# Output logs to the log host 1.1.1.1.
<Sysname> system-view
[Sysname] info-center loghost 1.1.1.1

info-center loghost source

Use info-center loghost source to specify the source IP address for output logs.
Use undo info-center loghost source to restore the default.
Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
Default
The source IP address of output logs is the primary IP address of the matching route's egress
interface.
Views
System view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies the egress interface for logs by the interface type and
interface number.
Usage guidelines
The system uses the primary IP address of the specified egress interface as the source IP address of
log information no matter which physical interface is used to output the logs.
The info-center loghost source command takes effect only after the information center is enabled
with the info-center enable command.
Examples
# Specify the IP address of interface loopback 0 as the source IP address of logs.
<Sysname> system-view
[Sysname] interface loopback 0
95