Switching The Instrument On - tecan Infinite 200 PRO Instructions For Use Manual

3. Installation
3.5

Switching the Instrument On

STOP
STOP
52
BEFORE THE INSTRUMENT IS SWITCHED ON FOR THE FIRST TIME
IT SHOULD BE LEFT TO STAND FOR AT LEAST 3 HOURS, SO THERE
IS NO POSSIBILITY OF CONDENSATION CAUSING A SHORT CIRCUIT.
1. Ensure the computer is switched OFF and the instrument's main power
switch on the back panel of the instrument is in the OFF position.
2. Connect the computer to the instrument with the delivered USB interface
cable.
3. Insert the power cable into the main power socket (with protective ground
connection) on the back panel of the instrument.
4. All connected devices must be approved and listed as per IEC 60950-1
Information Technology Equipment – Safety or equivalent local
standards.
5. Switch the instrument ON using the main power switch on the back panel
of the instrument.
THE READER HAS BEEN TESTED WITH THE SUPPLIED USB CABLE.
IF ANOTHER USB CABLE IS USED, TECAN AUSTRIA CANNOT
GUARANTEE THE CORRECT PERFORMANCE OF THE INSTRUMENT.
IFU for Infinite 200 PRO
CAUTION
AFTER INSTALLATION,
CAUTION
No. 30052730 Rev. No. 1.6 2016-04