Status Display; Save Setting Display; Fault Message Display; Polarity Setting Display - Delta ASD-B2-0121-B User Manual

4.3 Status Display

4.3.1 Save Setting Display

After the SET key is pressed, LCD display will show the following display messages for
approx. one second according to different status.
Display Message
4.3.2 Decimal Point Display
Display Message

4.3.3 Fault Message Display

Display Message

4.3.4 Polarity Setting Display

Display Message
Revision June 2010
The setting value is saved correctly. [Saved)
This parameter is read only. Write-protected. (Read-Only)
Invalid password or no password was input. (Locked)
The setting value is error or invalid. (Out of Range)
The servo system is running and it is unable to accept
this setting value to be changed. (Servo On)
This parameter is valid after restarting the drive. (Power
On)
High/Low byte display. When the data is a decimal 32-bit
data, these two digits are used to show if the display is
high byte or low byte.
Negative value display. When the data is displayed in
decimal format, the most left two digits represent negative
sign no matter it is a 16-bit or 32-bit data. If the data is
displayed in hexadecimal format, it is a positive value
always and no negative sign is displayed.
When the AC servo drive has a fault, LCD display will
display "ALnnn". "AL" indicates the alarm and "nnn"
indicates the drive fault code. For the list of drive fault
code, please refer to parameter P0-01 or refer to Chapter
11 (Troubleshooting).
Positive value display. When entering into parameter
setting mode, pressing UP or DOWN arrow key can
increase or decrease the display value. SHIFT key is used
to change the selected digit (The selected digit will
blink).
Chapter 4 Display and Operation
Description
Description
Description
Description
4-3