Tuning Flowchart - Delta ASD-B2-0121-B User Manual

Chapter 5 Trial Run and Tuning Procedure
20. The ratio of Load Inertia to Servo Motor Inertia (J_load /J_motor) cannot be shown in the
display of JOG parameter P4-05 operation. Please press MODE key twice continuously and
the users can see the ratio of Load Inertia to Servo Motor Inertia (J_load /J_motor). Then,
execute JOG operation again, press MODE key once and press SET key twice to view the
display on the keypad. Check if the value of J_load /J_motor is adjusted to a fixed value
and displayed on the keypad after acceleration and deceleration repeatedly.

5.5.1 Tuning Flowchart

5-12
Tuning Procedure Display
Revision June 2010