Status Monitor 2; Status Monitor 3 - Delta ASD-B2-0121-B User Manual

pulse number in pulse.
When reading the drive status through Modbus communication, the system should
read two 16-bit data stored in the addresses of 0012H and 0013H to form a 32-bit
data.
(0013H : 0012H) = (high byte : low byte)
When reading the drive ststus through the keypad, if P0-02 is set to 23, VAR-1 will
quickly show for about two seconds and then the value of P0-09 will display on the
display.
P0 - 10★ CM2
Default: N/A
Applicable Control Mode: ALL
Unit: N/A
Range: N/A
Data Size: 32-bit
Display Format: Decimal
Settings:
This parameter is used to provide the value of one of the status monitoring
functions found in P0-02. The value of P0-10 is determined by P0-18 (desired drive
status) through communication setting or the keypad. The drive status can be read
from the communication address of this parameter via communication port.
When reading the drive status through the keypad, if P0-02 is set to 24, VAR-2 will
quickly show for about two seconds and then the value of P0-10 will display on the
display.
P0 -11★ CM3
Default: N/A
Applicable Control Mode: ALL
Unit: N/A
Range: N/A
Data Size: 32-bit
Display Format: Decimal
Settings:
This parameter is used to provide the value of one of the status monitoring
functions found in P0-02. The value of P0-11 is determined by P0-19 (desired drive
status) through communication setting or the keypad. The drive status can be read
from the communication address of this parameter via communication port.
When reading the drive status through the keypad, if P0-02 is set to 25, VAR-3 will
quickly show for about two seconds and then the value of P0-11 will display on the
display.
Revision June 2010

Status Monitor 2

Status Monitor 3

Chapter 7 Servo Parameters
Address: 0014H, 0015H
Related Section:
Section 4.3.5
Address: 0016H, 0017H
Related Section:
Section 4.3.5
7-15