Table of Contents
Advertisement
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N3100-ON/N4000 series
switches.
The command provides the following information.
Term
Address Conflict
Detection Status
Last Conflicting IP
Address
Last Conflicting
MAC Address
Time Since Conflict
Detected
Example
console#show ip address-conflict
Address Conflict Detection Status...Conflict Detected
Last Conflicting IP Address.........10.131.12.56
Last Conflicting MAC Address........00:01:02:04:5A:BC
Time Since Conflict Detected........5 days 2 hrs 6 mins 46 secs
console#show ip address-conflict
Address Conflict Detection Status.............. No Conflict Detected
show ip helper-address
Use the show ip helper-address command to display IP helper addresses
configuration.
Syntax
show ip helper-address [vrf vrf-name][intf-address]
Description
Whether the switch has detected an address conflict on any IP
address. Set to Conflict Detected if detected, No Conflict
Detected otherwise.
The IP address that was last detected as conflicting on any
interface.
The MAC Address of the conflicting host that was last detected
on any interface.
The time in days, hours, minutes, and seconds since the last
address conflict was detected.
Switch Management Commands
1968
Advertisement
Table of Contents
