Configuring Mpls L2Vpn; Configuring Ccc Mpls L2Vpn; Configuration Prerequisites - H3C S9500 Series Operation Manual

Operation Manual – MPLS L2VPN
H3C S9500 Series Routing Switches

1.2 Configuring MPLS L2VPN

You can select any of the implementation methods for MPLS L2VPN as needed.
However, no matter what method you select, you must complete these two tasks:
Configuring MPLS basic capability
Enabling MPLS L2VPN on the PE device
Follow these steps to complete the above two tasks:
Enter system view
Configure the LSR ID
Configure MPLS basic capability
and enter MPLS view
Return to system view
Enable MPLS L2VPN

1.3 Configuring CCC MPLS L2VPN

Before configuring a CCC connection, you need to configure the interface connected to
the CE, namely the CE interface. For VLAN access, however, you do not need to
configure any VC.

1.3.1 Configuration Prerequisites

Before configuring CCC L2VPN, complete these tasks:
Configuring IGP on the PEs and P devices to guarantee the IP connectivity of the
MPLS backbone.
Configuring MPLS basic capability for the MPLS backbone on the PEs and P
devices.
Enabling MPLS L2VPN on PEs of the MPLS backbone. You do not need to enable
MPLS L2VPN on the P devices.
Note:
A local CCC connection involves no PE and therefore requires no IGP.
To configure CCC MPLS L2VPN, you need the following data:
Name for the CCC connection
Connection type: local or remote
To do...
Chapter 1 MPLS L2VPN Configuration
Use the command...
system-view
mpls lsr-id
mpls
quit
mpls l2vpn
1-7
Remarks
—
Required
Required
—
Required