Parameters: Drive Information - Danfoss FC 300 Design Manual

FC 300 Design Guide
Parameters: Drive Informa-
tion
15-** Operating Data
Parameter group containing frequency converter
information such as operating data, hardware
configuration and software versions.
15-0* Operating Data
Parameter group containing operating data e.g.
Operating Hours, kWh counters, Power Ups, etc.
15-00 Operating Hours
Value:
0 - 2147483647 h
Function:
View how many hours the frequency converter
has run. The value is saved when the frequency
converter is turned off.
15-01 Running Hours
Value:
0 - 2147483647 h
Function:
View how many hours the motor has run. Reset
the counter in par. 15-07. The value is saved
when the frequency converter is turned off.
15-02 kWh Counter
Value:
0 - 2147483647 kWh
Function:
View the power consumption from mains in kWh
as a mean value over one hour. Reset the counter
in par. 15-06.
15-03 Power Up's
Value:
0 - 2147483647
Function:
View the number of times the frequency converter
has been powered up.
15-04 Over Temp's
Value:
0 - 65535
factory setting
How to Programme
0h
0h
0kWh
() display text []
MG.33.B7.02 - VLT is a registered Danfoss trademark
Function:
View the number of frequency converter temper-
ature faults which have occurred.
15-05 Over Volt's
Value:
0 - 65535
Function:
View the number of frequency converter overvol-
tages which have occurred.
15-06 Reset kWh Counter
Value:
*Do not reset
Reset counter
Function:
Select Reset [1] and press [OK] to reset the kWh
counter to zero (see par 15-02). This parameter
cannot be selected via the serial port, RS 485.
Select Do not reset [0] if no reset of the kWh
counter is desired.
NB!
The reset is carried out by pressing
[OK].
15-07 Reset Running Hours Counter
Value:
Do not reset
Reset counter
Function:
Select Reset [1] and press [OK] to reset the Run-
ning Hours counter to zero (see par. 15-01). This
parameter cannot be selected via the serial port,
RS 485.
Select Do not reset [0] if no reset of the Running
Hours counter is desired.
0
15-1* Data Log Settings
The Data Log enables continuous logging of up to
4 data sources (par. 15-10) at individual rates
(par. 15-11). A trigger event (par. 15-12) and
window (par. 15-14) are used to start and stop
the logging conditionally.
0
value for use in communication via serial communication port
0
[0]
[1]
[0]
[1]
223