Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
Note
Note correct installation position.
♦
Parking lock lever must be flush with splines on shaft
♦
-arrow-.
If necessary, release spring pressure and align.
♦
Note
The roll pin can also be pressed in using pliers if necessary.
♦
Do NOT knock in the roll pin, as this will damage the shaft.
♦
– Press in roll pin using press tool - 3276/1- .
Tightening torques
♦
⇒ "1.1 Exploded view - selector mechanism", page 13
♦ ⇒ Engine; Rep. gr. 19 ; Coolant pipes; Exploded view - coolant
pipes
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Noise insula‐
tion; Exploded view - noise insulation
1.10
Renewing seal for parking lock shaft
Special tools and workshop equipment required
♦ Thrust piece - T10040/3-
Procedure
– Remove noise insulation (rear) ⇒ General body repairs, ex‐
terior; Rep. gr. 66 ; Noise insulation; Removing and installing
noise insulation .
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
37
1. Selector mechanism