Concluding Steps - Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual

System board and components

14.7.1.4 Concluding steps

Ê Reinstall all remaining system board components as shown in the related
sections:
I
Install all components into their original slots.
– Heat sinks:
– Memory modules:
– DynamicLoM module:
– Expansion cards:
"Installing expansion cards in standard slots" on page 295
"Installing a riser module" on page 95
– UFM (if applicable):
– TPM (if applicable):
– SATA DOM (if applicable):
– iRMC microSD card (if applicable):
on page 477
"Installing the system fan holder" on page 94
Ê
"Installing the system air duct" on page 92
Ê
"Installing a PSU" on page 147
Ê
"Reassembling" on page 74
Ê
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
Ê Reconnect all external cables.
"Connecting the power cord" on page 87
Ê
"Switching on the server" on page 90
Ê
"Updating or recovering the system board BIOS and iRMC" on page 119
Ê
"Verifying system information backup / restore" on page 121
Ê
"Verifying the system time settings" on page 132
Ê
490
"Installing heat sinks" on page 385
"Installing a memory module" on page 360
"Installing the DynamicLoM module" on page 336
"Installing the UFM" on page 454
"Installing the TPM" on page 463
"Installing the SATA DOM" on page 473
Upgrade and Maintenance Manual
"Installing the iRMC microSD card"
TX2560 M2 / RX2560 M2