Installing The Dynamiclom Module; Preliminary Steps - Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual

Expansion cards and backup units
P1
P0
Figure 244: MAC label D3275 (alternative D3285)
9.5.2

Installing the DynamicLoM module

Upgrade and Repair Unit
(URU)
Tool: – Phillips PH0 / (+) No. 0 screw driver
– hexagon screw driver 5 mm
– Phillips PH2 / (+) No. 2 screw driver (for system board screw)
9.5.2.1

Preliminary steps

"Disabling SVOM boot watchdog functionality" on page 112
Ê
"Shutting down the server" on page 58
Ê
"Disconnecting the power cord" on page 59
Ê
"Getting access to the component" on page 61
Ê
Ê If applicable, remove the riser module 1 as described in section
a riser module" on page
336
98.
Upgrade and Maintenance Manual
P0:xxxx xxxx xxx0 - 7
P1:xxxx xxxx xxx8 - F
Hardware: 5 minutes
TX2560 M2 / RX2560 M2
"Removing