7.4.2.5
Cabling the 8x 2.5-inch HDD extension box
Figure 155: Connecting the 8x 2.5-inch HDD extension box
Ê Connect the SAS cable C11 from backplane connector X9 to the expander
board connector X14 (1).
Ê Connect the power cable C6 from backplane connector X40 to the system
board connector PWR 12V3 (2).
Ê Connect the SAS cable C11 from backplane connector X10 to the expander
board connector X15 (3).
Ê If applicable, connect the OOB cable (see cabling plan in
page
530).
I
For a complete cabling overview, please refer to section
on page
512.
7.4.2.6
Installing HDD modules into the 8x 2.5-inch HDD extension box
"Reassembling" on page 74
Ê
Ê Install HDD modules or HDD dummy modules into the additional HDD bays
as described in sections
page 174
and
I
For detailed information on HDD mounting order, refer to section
inch HDD/SSD/PCIe SSD configurations" on page
TX2560 M2 / RX2560 M2
Hard disk drive (HDD) / solid state drive (SSD)
"Installing a 2.5-inch HDD/SSD module" on
"Installing a 2.5-inch HDD/SSD dummy module" on page
Upgrade and Maintenance Manual
figure 402 on
"Cabling plans"
177.
"2.5-
155.
241