System board and components
14.3.2.2 Removing the UFM
Figure 341: Removing the UFM
Ê Remove the nylon screw of the UFM (1).
Ê Disconnect and remove the UFM (2).
The UFM spacer remains on the system board.
Figure 342: Remaining UFM spacer on system board
V
CAUTION!
UFM contains customer information (e.g. IP address, License etc.). After
removing the UFM, you must pass the UFM to the customer.
14.3.2.3 Concluding steps
Ê If applicable, install the expansion card in slot 1 as described in section
"Installing expansion cards in standard slots" on page
"Reassembling" on page 74
Ê
458
Upgrade and Maintenance Manual
295.
TX2560 M2 / RX2560 M2