Installing The Cpu; Concluding Steps - Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual

11.4.2.2 Installing the CPU

Ê Install the CPU as described in section

11.4.3 Concluding steps

"Installing heat sinks" on page 385
Ê
"Installing the system air duct" on page 92
Ê
"Reassembling" on page 74
Ê
"Connecting the power cord" on page 87
Ê
"Switching on the server" on page 90
Ê
I
When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the error
message CPU has been changed. This only indicates that the CPU
configuration has been altered. There is no technical problem.
In order to turn off the Global Error indicator, please proceed as follows:
Ê Restart the system and wait for screen output to appear.
Ê Press the [F2] function key to enter the BIOS.
If assigned, enter the BIOS password and press [Enter].
Ê In the Save & Exit menu, select Save Changes and Exit or Save Changes
and Reset.
Ê Ensure that the Global Error indicator has stopped flashing. This is
only information regarding to the change of CPU configuration. There
is no technical problem.
"Updating or recovering the system board BIOS and iRMC" on page 119
Ê
"Resetting the error status after replacing memory modules or processors"
Ê
on page 126
"Enabling SVOM boot watchdog functionality" on page 130
Ê
"Enabling replaced components in the system BIOS" on page 131
Ê
"Resuming BitLocker functionality" on page 136
Ê
TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual
"Installing a CPU" on page
Processor (CPU)
370.
383