Replacing The Ufm; Preliminary Steps; Removing The Defective Ufm - Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual

"Connecting the power cord" on page 87
Ê
"Switching on the server" on page 90
Ê
"Resuming BitLocker functionality" on page 136
Ê

14.3.3 Replacing the UFM

Upgrade and Repair Unit
(URU)
Tools: – Phillips PH1 / (+) No. 1 screw driver
– combination pliers and flat nose pliers

14.3.3.1 Preliminary steps

"Locating the defective server" on page 55
Ê
"Suspending BitLocker functionality" on page 111
Ê
"Disabling SVOM boot watchdog functionality" on page 112
Ê
"Shutting down the server" on page 58
Ê
"Disconnecting the power cord" on page 59
Ê
"Getting access to the component" on page 61
Ê
Ê If applicable, remove an expansion card in slot 1 as described in section
"Removing expansion cards from standard slots" on page

14.3.3.2 Removing the defective UFM

Ê Remove the UFM as described in section
page 457.
Ê The UFM spacer remains on the system board.
TX2560 M2 / RX2560 M2 Upgrade and Maintenance Manual
System board and components
Hardware: 10 minutes
Software: 5 minutes
300.
"Removing the UFM" on
459