Replacing A Tfm; Preliminary Steps - Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual

Ê If applicable, update the firmware of the RAID controller that has been
connected to the FBU as described in section
firmware" on page
"Enabling SVOM boot watchdog functionality" on page 130
Ê
I
The recalibration of the FBU starts automatically, and finishes within a
few minutes.
9.4.5

Replacing a TFM

Upgrade and Repair Unit
(URU)
Tools: Phillips PH1 / (+) No. 1 screw driver
V
CAUTION!
For further safety information, please refer to chapter
information" on page
9.4.5.1

Preliminary steps

"Disabling SVOM boot watchdog functionality" on page 112
Ê
"Locating the defective server" on page 55
Ê
"Shutting down the server" on page 58
Ê
"Disconnecting the power cord" on page 59
Ê
"Getting access to the component" on page 61
Ê
Ê Disconnect the SAS cables from the SAS RAID controller.
Ê Remove the SAS RAID controller from its slot as described in section
"Removing expansion cards from standard slots" on page
TX2560 M2 / RX2560 M2
122.
43.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Updating RAID controller
Hardware: 10 minutes
"Important
300.
329