14.4.3 Replacing the TPM
Field Replaceable Unit
(FRU)
Tools: Removing the system board:
– Phillips PH2 / (+) No. 2 screw driver
Replacing the TPM:
– Bit screw driver
– TPM bit insert
– flat nose pliers
– thin slotted screw driver (2 x 0.4 mm)
(
)
*
For the Japanese market:
– Dedicated TPM screw driver (CWZ8291A)
– TPM module fixing tool (S26361-F3552-L909)
V
CAUTION!
Advise your contact persons that they must provide you with TPM
backup copies. For security reasons, the TPM must be restored/re-
saved by the customer. After installing a new system board, the TPM
must be enabled. You may not clear the TPM data.
If the contact persons DO NOT have a backup copy available, inform
them that replacing the TPM board will cause to lose all data.
14.4.3.1 Preliminary steps
"Locating the defective server" on page 55
Ê
"Suspending BitLocker functionality" on page 111
Ê
"Shutting down the server" on page 58
Ê
"Disconnecting the power cord" on page 59
Ê
"Getting access to the component" on page 61
Ê
Ê If applicable, remove the riser module 1 as described in section
a riser module" on page
TX2560 M2 / RX2560 M2
(
)
*
98.
Upgrade and Maintenance Manual
System board and components
Hardware: 40 minutes
(
)
*
"Removing
471