Vertical Drive Roller Timing Belt Adjustment - Ricoh A109 Service Manual

4.3 VERTICAL DRIVE ROLLER TIMING BELT ADJUSTMENT

Standard:
Measurement:
Part to adjust:
4.4 SORTER MOTOR SPEED ADJUSTMENT
CAUTION: - Always perform the high motor speed adjustment first.
- Make sure to check the low motor speed after adjusting
the high motor speed.
- LED102 takes sometime before responding to the
adjustment. Wait 2 to 3 seconds after adjusting the VR,
then check LED102.
1. Remove the sorter upper
cover (3 screws).
2. Remove the sorter rear cover
(4 screws).
3. Turn on DPS100-2, 4 on the
sorter main PCB. By using
VR100, adjust the high motor
speed so that LED 102 lights
on.
4. Turn on DPS100-2 on the
sorter main PCB. By using
VR101, adjust the low motor
speed so that LED102 lights
on.
A109
14 ± 1.5 mm reflection at 200 g
Take the measurement at the center,
between the pulley and the belt tightner roller
[A].
Belt tightner bracket [B] (1 screw)
200 g
14 ± 1.5 mm [A]
8-16
[B]
FSM