Replace Roms And Reassemble The Machine; Connect To The Fiery And Adjust The Printer Gamma - Ricoh A109 Service Manual

4.2.5 Replace ROMs and reassemble the machine

1. Replace the ROM (IC303) on the IPU board.
2. Replace the ROM (IC309) on the IPU board.
3. Replace the ROM (IC509) on the main board.
4. Replace the ROM (IC522) on the main board.
5. Re-assemble the machine.

4.2.6 Connect to the Fiery and adjust the printer gamma

The printer gamma must be adjusted for both Fiery print mode settings
(halftone and contone).
1. Connect the Fiery controller to the controller interface connector with the
cable provided from EFI.
2. First turn on the copier. When the copier in standing by, turn on the Fiery
controller.
3. Watch the Fiery boot up. When "Press ESC to run Fiery Setup" is
displayed, press the ESC key.
4. Press Enter until the "Enable halftone printing" setting is displayed.
Then select Yes with the "→" key and press Enter.
5. When the "Default print mode" setting is displayed, select halftone.
6. Press Enter until "Save changes: No/Yes/Quit" is displayed.
7. If you changed either of the settings in steps 4 and 5, select Yes then
press Enter. Otherwise, select Quit then press Enter. The Fiery
continues its startup routine.
NOTE: If you made a mistake during set-up, select No and do the set-up
all over again.
8. When the Fiery controller enters idle mode, press the F4 key to print a
test page.
Controller Interface Kit Type-A 11 A109