Replacement And Adjustment - Ricoh A109 Service Manual

4. REPLACEMENT AND ADJUSTMENT

4.1 SORTER MOTOR, SPONGE ROLLER, AND INLET
SENSOR REPLACEMENT
[D]
[C]
NOTE: Be careful not to lose the positioning pin [A].
1. Remove all sorter bins, then remove the sorter from the copier. (See the
Sorter Removal section.)
2. Remove the sorter motor [B] (4 screws, E-ring, ground-wire).
3. Remove the inlet guide board unit [C] (4 screws).
4. Remove the roller drive pulley (1 allen-screw) and replace the sponge
roller [D].
5. Remove the inlet sensor with the bracket on [E] (2 screws).
6. Pull out the harness and replace the sensor [F].
A109
[E]
[A]
8-14
[F]
[B]
FSM